New Products: More Shields For ESPea

BMP280 shield for ESPea. The BMP280 sensor can measure barometric pressure and temperature with very good accuracy. This shield is good match with ESPea, ESPea32. It also has nice size. Buy Link ESPea Relay Shield for ESPea. This is the ESPea Relay Shield, an add-on board that allows your ESPea to control higher voltage and current loads…

New Product: OLED Shield For ESPea

128×64 pixels OLED Shield with I2C. It adds a 128×64 monochrome OLED to ESPea main board. The OLED uses only the two I2C pins on the ESPea, and you can pretty much stack it with ESPea, even ones that use I2C since that is a shared bus. Buy Link. Prototype Shield For ESPea is also…

New Product Available: ESPea Dev Board

ESPea is a new Wi-Fi development board from AprilBrother technologies. It uses the ESP8266EX chipset as the main micro-controller and supports the Arduino environment. At the ESPea’s heart is an ESP8266 WiFi microcontroller clocked at 80 MHz and at 3.3V logic. This microcontroller contains a Tensilica chip core as well as a full WiFi stack.…

New Product: BLEPad available

BLEPad – The BLEPad is an Arduino compatible microcontroller development board based on the ATmega32U4 IC with Bluetooth 4.0. a.k.a. Bluetooth Low Energy (BLE), built in. You can choose board type LilyPad Arduino USB from Arduino IDE to start programming. It’s the easiest way to get Bluetooth 4.0 in your project!

New Product: BlueDuino Rev2 available

The BlueDuino Rev2 is an Arduino compatible microcontroller development board based on the ATmega32U4 IC with Bluetooth 4.0. a.k.a. Bluetooth Low Energy (BLE), built in. Just plug in the board and your ready to start programming! It’s the easiest way to get Bluetooth 4.0 in your project!

Buy it on tindie.

New products: A CP2102 USB to UART converter support ESP8266

We have some little new products this week! USB To UART converter Supports ESP8266 A CP2102 3.3V USBToUART converter support 400mA+ current. Good for upload firmware for esp8266. Tiny Double Side Thru-Hole Prototype PCB Board The Prototype PCB Board for Pro Micro / Arduino Pro Mini / Cactus Micro allows easy prototyping using through-hole components.…

New Product: TinyESP ESP8266 Breadboard Adapter

TinyESP is a tiny size breadboard adapter for ESP-12/ESP-07 ESP8266 WiFi module. It contains a 3.3V voltage LDO, a Reset button and a flash jumper. Please refer the link for more information. Why did you make it? ESP8266 is an inexpensive serial-to-wifi tranceiver chip that can be used to connect any microcontroller with a serial…